[Maleficus]

This is a VERY basic and rough guide on how to use the included tools with FritzBot.

First off, by default the tools are disabled. This is to conserve memory and processor power. I know its a pain, but its VERY important for older systems to keep them disabled by default.

There are three things you have to do to enable the tools:

1. Be sure you started the map you want to waypoint in developer/cheat mode (i.e. "devmap mp_keep" if mp_keep is the map you want to waypoint).

2. Type "node_editor 1" into the console to actually activate the tools.

3. Type "vid_restart" into the console to make your changes take effect.

The FritzBot tools are all console based, though there is two different huds available to give you feedback about your path file.

Type "node_drawhud 1" and "node_vis 1" into the console to activate the node graphical hud and path drawing code, respectively.

ATM, if you haven't pathed this map yet, you'll see nothing.

Its time to add your first node.