New at MinGW! How to use it?
Hello,
I installed the latest version of Mingw (full). Now I am trying to compile a librar. The instructions say : ./configure --with-our-malloc16 --with-windows-f77-mangling --enable-shared --disable-static --enable-threads --with-combined-threads --enable-portable-binary --enable-sse2 make make install What are the equivalent commands for these lines? Cristian |
Re: New at MinGW! How to use it?
Normally you'll get a command line with mingw (msys was it?), you'll need to open that and then go into the library source directory, from where you can run those commands. I'll admit it's been a while since I dipped into mingw, so I'm not sure if anything else needs setting up, or if the installer will do it all for you.
|
Re: New at MinGW! How to use it?
Cool. Thanks a lot.
CVA |
All times are GMT +2. The time now is 15:38. |
Powered by vBulletin® Version 3.8.2
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.